ASSRA Forum › General › Gunsmithing Single Shot Rifles › Help Guess the Buttplate ...
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Help Guess the Buttplate ... (Read 444 times)
ssdave
Frequent Elocutionist
*****
Offline



Posts: 2191
Location: Eastern Oregon
Joined: Apr 16th, 2004
Re: Help Guess the Buttplate ...
Reply #15 - yesterday at 8:36pm
Print Post  
I was envious of that stock, Joe.  It would be great on my #5 project that I purchased from you a while back.

Bought a gun/reloading estate today, and there were two spectacular blanks in it!  The walnut didn't photograph very well, but has some very nice grain to it!

(You need to Login or Register to view media files and links)
(You need to Login or Register to view media files and links)
  
Back to top
 
IP Logged
 
ssdave
Frequent Elocutionist
*****
Offline



Posts: 2191
Location: Eastern Oregon
Joined: Apr 16th, 2004
Re: Help Guess the Buttplate ...
Reply #16 - Today at 2:45am
Print Post  
Had to scrape off the wax and sand it a bit to see what the grain will look like.  Usually on walnut, have to work to get it dark enough.  I put some turpentine on this one on one side, and it got very dark.  I don't think I'll be adding a dark finish to it.  

Best of all, it's almost 2-3/4" thick.

(You need to Login or Register to view media files and links)
(You need to Login or Register to view media files and links)
(You need to Login or Register to view media files and links)
(You need to Login or Register to view media files and links)
(You need to Login or Register to view media files and links)
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.4946 seconds.