ASSRA Forum - Fx for a slding extractor Swedish rolling block

ASSRA Forum › General › Gunsmithing Single Shot Rifles › Fx for a slding extractor Swedish rolling block

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

Fx for a slding extractor Swedish rolling block (Read 138 times)

BillOregon Full Member Offline Posts: 196 Location: Hurley, New Mexico Joined: Jul 28^th, 2006	Fx for a slding extractor Swedish rolling block Jul 11^th, 2026 at 9:22pm	Print Post
	Fix for a sliding extractor 1873 Gustafs 12,7X44 R rolling block that doesn't always grab the case and lift it out. This has likely been covered oh, a hundred times before.


	IP Logged

marlinguy Frequent Elocutionist Offline Ballards may be weaker, but they sure are neater! Posts: 18110 Location: Oregon Joined: Feb 2^nd, 2009	Re: Fx for a slding extractor Swedish rolling block Reply #1 - Jul 12^th, 2026 at 10:28am	Print Post
	Only fix I know of Bill is to get another extractor, or take the one that doesn't quite work and have a good welder build up the end of the extractor to get a better grasp on the rim. Of course you'll need to shape the weld back down carefully until it fits and works properly. I prefer this method as another used extractor might not be any better. Or for $20 you can buy a new casting from The Rifle Shoppe and fit it to your case rim. (You need to *Login* or *Register* to view media files and links)

	(You need to *Login* or *Register* to view media files and links)
	IP Logged

craigster Oldtimer Offline Posts: 827 Location: lost coast CA Joined: Feb 20^th, 2011	Re: Fx for a slding extractor Swedish rolling block Reply #2 - Today at 1:02pm	Print Post
	Give Ken a call. (You need to *Login* or *Register* to view media files and links)


	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 0.7665 seconds.