ASSRA Forum › General › Gunsmithing Single Shot Rifles › Ballard lever screw dimensions
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Ballard lever screw dimensions (Read 108 times)
cellargun
Full Member
***
Offline



Posts: 168
Joined: Feb 28th, 2022
Ballard lever screw dimensions
Apr 15th, 2026 at 1:58pm
Print Post  
As the title says, I need dimensions for a Ballard lever screw. I know I have seen it recently but search said no matches.
Memory says .277-40, but I would rather know for certain.
Thanks, Richard
  
Back to top
 
IP Logged
 
idjeffp
Senior Forum Member
****
Offline



Posts: 363
Location: Boise, ID
Joined: Nov 11th, 2017
Re: Ballard lever screw dimensions
Reply #1 - yesterday at 5:07pm
Print Post  
From a print I have... Hope this helps Wink
Jeff P
  
Back to top
 
IP Logged
 
KensBullard
Junior Member
**
Offline



Posts: 68
Location: Woodland Wa
Joined: Dec 17th, 2024
Re: Ballard lever screw dimensions
Reply #2 - yesterday at 11:06pm
Print Post  
Most of the scerw sizes in those Prints are off in someway off some not so far but most are off I have in my drawings of screws .227 X40 ken
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.4831 seconds.