ASSRA Forum › General › Gunsmithing Single Shot Rifles › Highwall question
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Highwall question (Read 457 times)
JKR
Junior Member
**
Offline



Posts: 83
Joined: Nov 2nd, 2021
Highwall question
Jun 1st, 2025 at 12:49pm
Print Post  
If I were to change my straight grip, single non set trigger, to a pistol grip lower tang, using an MVA lower tang, would the trigger parts work with the new trigger plate?
  
Back to top
 
IP Logged
 
calledflyer
Frequent Elocutionist
*****
Offline



Posts: 3722
Joined: Mar 9th, 2015
Re: Highwall question
Reply #1 - Jun 1st, 2025 at 1:35pm
Print Post  
might need a little fitting when using the MVA pistol grip tang, but on an original the parts were interchangeable. The bending came behind the trigger.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.8411 seconds.