ASSRA Forum › General › Gunsmithing Single Shot Rifles › highwall double set sears
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic highwall double set sears (Read 208 times)
gunlaker
Frequent Elocutionist
*****
Offline



Posts: 2331
Location: lower mainland, B.C.
Joined: Dec 13th, 2010
highwall double set sears
Nov 29th, 2024 at 3:51pm
Print Post  
Hi,

Based on the pictures in Campbells book, there is very little difference between a close coupled DST sear and the standard DST sear.  Has anyone tried using the close coupled sear with standard double set triggers?

thanks,

Chris.
  
Back to top
 
IP Logged
 
GT
Frequent Elocutionist
*****
Offline



Posts: 2050
Location: Northeast Wyoming
Joined: Jun 28th, 2015
Re: highwall double set sears
Reply #1 - Nov 29th, 2024 at 8:27pm
Print Post  
Chris,
I've made several CC's from scratch and a couple dbl sets the same, all of mine have worked using the same long tail sear design.  Both of these triggers use similar mouse traps features.  The cut out for the fly in the sear is needed if you are making the sear from scratch.  Just a little tidbit from experience...
Greg
  
"To invent, you need a good imagination and a pile of junk"  T. A. Edison
"The trouble ain't that there is too many fools, but that the lightning ain't distributed right" M.T.
Back to top
 
IP Logged
 
gunlaker
Frequent Elocutionist
*****
Offline



Posts: 2331
Location: lower mainland, B.C.
Joined: Dec 13th, 2010
Re: highwall double set sears
Reply #2 - Nov 30th, 2024 at 9:36am
Print Post  
Thanks Greg.  I actually have a rifle with CC DST triggers, and a while ago I bought a couple of the wide DST tang & trigger assemblies with levers.  I was just wondering if I could swap them.  I guess I'll give it a try.

Chris.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.3232 seconds.