ASSRA Forum › General › Gunsmithing Single Shot Rifles › Pedersoli Silhoette Creedmoor sight mounting base
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Pedersoli Silhoette Creedmoor sight mounting base (Read 92 times)
runningiron
Full Member
***
Offline



Posts: 129
Location: Texas
Joined: Jun 12th, 2007
Pedersoli Silhoette Creedmoor sight mounting base
Oct 4th, 2024 at 2:58pm
Print Post  
I just traded for this sight, but it did not come with a base plate for mounting on my rifle (or any rifle, for that matter). I've searched the web but have been unable to find just the base. Does anyone have any ideas on where I can get on or adapt one? The sight will go on a Remington Rolling Block No.5 in .45-70.
Davide Pedersoli Silhouette Creedmoor Sight - USA 431
  
Murphy was an optimist
Back to top
 
IP Logged
 
runningiron
Full Member
***
Offline



Posts: 129
Location: Texas
Joined: Jun 12th, 2007
Re: Pedersoli Silhoette Creedmoor sight mounting base
Reply #1 - Oct 4th, 2024 at 3:33pm
Print Post  
Problem solved. Lee Shaver had one to fit. So, I'm good.
  
Murphy was an optimist
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.1100 seconds.