ASSRA Forum › General › Gunsmithing Single Shot Rifles › Winchester forend insert
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Winchester forend insert (Read 620 times)
steel-pounder
Full Member
***
Offline



Posts: 141
Joined: Mar 26th, 2016
Re: Winchester forend insert
Reply #15 - Sep 22nd, 2024 at 10:33am
Print Post  
in all the pictures I can find online it looks like the bottom of the insert recess is concaved. is this so or is it flat and looks concaved because of the rounding of the forend and the picture?
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.5396 seconds.