ASSRA Forum - Borchardt forend escutions

ASSRA Forum › General › Gunsmithing Single Shot Rifles › Borchardt forend escutions

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Page Index Toggle

Pages: 1

Normal Topic

Borchardt forend escutions (Read 210 times)

jhm Frequent Elocutionist Offline Posts: 1405 Location: georgia Joined: Sep 4^th, 2011	Borchardt forend escutions Sep 14^th, 2024 at 7:09pm	Print Post
	Getting ready to attach the forend on my Borchardt build. The wood came from CPA. I have seen a picture of the rear most escutions and it is an oval shape that uses both screws. The wood attachment screw and also the lever spring screw. My question is how does the rear most screw hold both the lever spring and forend? JMH


	IP Logged

jfeldman ASSRA Board Member Offline Posts: 1079 Location: Imperial Beach, Ca Joined: Nov 5^th, 2005	Re: Borchardt forend escutions Reply #1 - Sep 14^th, 2024 at 7:29pm	Print Post
	jhm, it doesn't hold the wood, just the spring. The escutcheon rear hole just slides over the screw and the front screw attaches the wood. Regards, Joe


	IP Logged

idjeffp Senior Forum Member Offline Posts: 285 Location: Boise, ID Joined: Nov 11^th, 2017	Re: Borchardt forend escutions Reply #2 - Sep 15^th, 2024 at 6:47pm	Print Post
	Maybe these will help? I had the action apart on my bench as well as the drawing. You can see a walnut remnant from the old forend trapped between the screws.. Cheers! Jeff P


	IP Logged

jhm Frequent Elocutionist Offline Posts: 1405 Location: georgia Joined: Sep 4^th, 2011	Re: Borchardt forend escutions Reply #3 - Sep 15^th, 2024 at 8:57pm	Print Post
	Pictures are worth a thousand words.... Mystery solved. Thanks JMH


	IP Logged

Page Index Toggle

Pages: 1

‹ Previous Topic | Next Topic ›

« Board Index ‹ Board Top

Top

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid XHTML

Valid CSS

Powered by Perl

Source Forge

Page completed in 0.5425 seconds.