ASSRA Forum › General › Gunsmithing Single Shot Rifles › Uberti Hiwall barrel tenon
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Uberti Hiwall barrel tenon (Read 409 times)
Steve L
Newbie
*
Offline



Posts: 1
Joined: Sep 7th, 2013
Uberti Hiwall barrel tenon
Jul 27th, 2024 at 6:42pm
Print Post  
Anyone know the dimensions? Thank you in advance. nvtoy
  
Back to top
 
IP Logged
 
singleshotsam
Oldtimer
*****
Offline



Posts: 551
Location: Silver City NM
Joined: Jan 15th, 2009
Re: Uberti Hiwall barrel tenon
Reply #1 - Aug 2nd, 2024 at 7:07pm
Print Post  
I have one in the shop at this time, I will check the dimensions and post them tomorrow.
  
Back to top
 
IP Logged
 
singleshotsam
Oldtimer
*****
Offline



Posts: 551
Location: Silver City NM
Joined: Jan 15th, 2009
Re: Uberti Hiwall barrel tenon
Reply #2 - Aug 3rd, 2024 at 12:16pm
Print Post  
After checking a current manufacture Uberti 1885 in 45-70 the barrel shank dimensions are as follows.
Thread size is .935 major diameter
20 TPI
.845 shank length
I hope this is helpful and answers your question.
  
Back to top
 
IP Logged
 
bpjack
Frequent Elocutionist
*****
Offline



Posts: 2662
Location: East Olympia, WA
Joined: May 18th, 2008
Re: Uberti Hiwall barrel tenon
Reply #3 - Aug 3rd, 2024 at 12:54pm
Print Post  
So close to an original large shank Winchester.  Too bad they didn't copy that.

Just sayin'

Jack
  
ASSRA # 11318
just a bit of a hoot.
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.3874 seconds.