ASSRA Forum › General › Gunsmithing Single Shot Rifles › Ballard Hammer Spring
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Ballard Hammer Spring (Read 414 times)
Myers
Senior Forum Member
****
Offline



Posts: 373
Joined: Mar 5th, 2013
Ballard Hammer Spring
Mar 12th, 2024 at 9:06pm
Print Post  
Looking for anyone who replaced one with a Steve Earle and noticed a difference with hammer fall.
  
Back to top
 
IP Logged
 
jfeldman
ASSRA Board Member
*****
Offline



Posts: 1061
Location: Imperial Beach, Ca
Joined: Nov 5th, 2005
Re: Ballard Hammer Spring
Reply #1 - Mar 12th, 2024 at 10:48pm
Print Post  
Keith, I put one Steve's mainsprings in my 22 ballard, the one with the roller tip, and it was a lot smoother and I believe a tad faster.  I think that Schuetzenbob used one as well.

Regards,
Joe
  
Back to top
 
IP Logged
 
830singleshot
Senior Forum Member
****
Offline



Posts: 394
Location: Texas
Joined: Feb 11th, 2007
Re: Ballard Hammer Spring
Reply #2 - Mar 13th, 2024 at 12:19am
Print Post  
Exactly my experience.  What a bargain for that roller tipped spring
  
J. Scott McCash&&New Braunfels, TX&&830-237-2376&&jsmccash@yahoo.com
Back to top
 
IP Logged
 
bnice
Frequent Elocutionist
*****
Offline



Posts: 1815
Location: Iowa
Joined: Nov 30th, 2006
Re: Ballard Hammer Spring
Reply #3 - Mar 13th, 2024 at 7:30pm
Print Post  
My experience as well.
  
Back to top
 
IP Logged
 
Myers
Senior Forum Member
****
Offline



Posts: 373
Joined: Mar 5th, 2013
Re: Ballard Hammer Spring
Reply #4 - Mar 13th, 2024 at 11:34pm
Print Post  
Sounds good just ordered two of them.

Good Shooting!
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.4463 seconds.