ASSRA Forum › General › Gunsmithing Single Shot Rifles › Need a .38 S&W cylinder reamer
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Need a .38 S&W cylinder reamer (Read 122 times)
Otony
Full Member
***
Offline



Posts: 174
Location: Walla Walla/Bandon
Joined: Jun 5th, 2021
Need a .38 S&W cylinder reamer
Nov 13th, 2022 at 4:49pm
Print Post  
Not .38 Special, the older, shorter, slightly fatter .38 S&W cartridge.

I’m wondering if anyone here knows of a ‘smith with the reamer to cut a revolver cylinder, NOT a rifle barrel

Yes, I have too much time on my hands….
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.5066 seconds.