ASSRA Forum › General › Gunsmithing Single Shot Rifles › Sharps Borchardt switch-barrel
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Sharps Borchardt switch-barrel (Read 449 times)
.22-5-40
Oldtimer
*****
Offline



Posts: 774
Joined: Feb 13th, 2010
Sharps Borchardt switch-barrel
Sep 23rd, 2022 at 11:13am
Print Post  
Concerning a Sharps Borchardt switch-barrel..what is the procedure for removing barrel?  Does breech block need to be removed.  If case heads are the same size, does this simplify things (no need to change out extractor).
  
Back to top
 
IP Logged
 
John Taylor
Frequent Elocutionist
*****
Offline



Posts: 1644
Location: Lewiston, ID
Joined: Oct 23rd, 2006
Re: Sharps Borchardt switch-barrel
Reply #1 - Sep 24th, 2022 at 10:52pm
Print Post  
The extractor may not come back far enough to clear the barrel. Most likely the breach block and extractor will need to be removed.
  
John Taylor   Machinist/gunsmith
Back to top
WWW  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.2091 seconds.