ASSRA Forum › General › Gunsmithing Single Shot Rifles › High Wall tang screws
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic High Wall tang screws (Read 832 times)
waterman
Frequent Elocutionist
*****
Offline



Posts: 3002
Location: Behind the Redwood Curtain
Joined: Jun 9th, 2004
High Wall tang screws
Aug 1st, 2021 at 7:12pm
Print Post  
Where can I get a long tang screw for an original High Wall?  One that will hold down the rear of a tang sight.
  
Back to top
 
IP Logged
 
George Babits
Frequent Elocutionist
*****
Offline



Posts: 1151
Joined: Sep 27th, 2012
Re: High Wall tang screws
Reply #1 - Aug 1st, 2021 at 8:46pm
Print Post  
MVA or Homestead Firearms should have them.   

George
  
Back to top
 
IP Logged
 
idjeffp
Senior Forum Member
****
Offline



Posts: 364
Location: Boise, ID
Joined: Nov 11th, 2017
Re: High Wall tang screws
Reply #2 - Aug 1st, 2021 at 10:44pm
Print Post  
Smiley

I just made a set from some 1144 to mount my FZika Soule tangsight. Fun stuff... I have no idea if the head sizes needed for this tangsight are standard or not, but made them to fit nicely. It's a beautiful sight (Thanks Bullseyetom!) so worth my time to just make the pair.

Of course when I was in there I found the main sear spring screw with half a head missing so made that one too. Made sure to check that the length of the front tangsight screw was not interfering with the sear spring when seated.

Cheers!
Jeff Pfeifer
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0382 seconds.