(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic tap size (Read 768 times)
nuclearcricket
Oldtimer
*****
Offline



Posts: 823
Joined: Oct 15th, 2008
tap size
May 8th, 2021 at 10:34am
Print Post  
I know this may be a bit of a long shot, but does anyone know that the proper tap size would be for the screw on a Winchester Windguage front sight?
TIA
Sam
  
Back to top
 
IP Logged
 
tdmidget
Junior Member
**
Offline



Posts: 52
Joined: Jan 21st, 2016
Re: tap size
Reply #1 - May 8th, 2021 at 10:23pm
Print Post  
What screw? And tap size refers to the clearance in the threads , so what thread? You are asking a wrong and non question.
  
Back to top
 
IP Logged
 
rkba2nd
Frequent Elocutionist
*****
Offline



Posts: 2103
Location: earth
Joined: Feb 16th, 2009
Re: tap size
Reply #2 - May 8th, 2021 at 11:29pm
Print Post  
I believe it is ssrifles on this site who makes very good copies of original sights. You might PM him for your answer.
  
rkba2nd
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.2495 seconds.