ASSRA Forum › General › Gunsmithing Single Shot Rifles › Looking for Info On rolling Block
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Looking for Info On rolling Block (Read 1016 times)
Bonner
Full Member
***
Offline



Posts: 135
Location: middle georgia
Joined: Mar 2nd, 2015
Looking for Info On rolling Block
Mar 14th, 2018 at 4:47pm
Print Post  
Looking for information on a roller that came out of Burke's Gun Shop ( Auction ) in Laceyville, Pa. Look's like it was restocked and barreled. The barrel has  5/30/01 and BMP on it . Trying to find out who did this work. Thanks for any help, it is a Sunny day here in middle GA. Bonner
« Last Edit: Mar 14th, 2018 at 6:33pm by Bonner »  
Back to top
 
IP Logged
 
Schuetzendave
Frequent Elocutionist
*****
Offline


Retired Ex-Shooter

Posts: 4107
Location: St. Albert, Alberta
Joined: Jan 28th, 2005
Re: Looking for Info On rolling Block
Reply #1 - Mar 14th, 2018 at 6:46pm
Print Post  
Just guessing it was done by an individual for himself.

Gunsmith's have inline stamp holders and the numbers/letters would have been straighter if done by a gunsmith.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.4183 seconds.