ASSRA Forum › General › Gunsmithing Single Shot Rifles › Need Help - Problem with LW.
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Need Help - Problem with LW. (Read 5959 times)
kelleyrepair
Participating Member
*
Offline



Posts: 20
Location: Baja New York (FL)
Joined: Apr 28th, 2012
Re: Need Help - Problem with LW.
Reply #15 - Mar 18th, 2018 at 11:16am
Print Post  
My best guess is that this problem is caused by the link pushing the hammer back a bit too much at that binding point, because the MVA part has a little more material in this area.  Removing a small amount of material from the camming lobe of your LINK might remedy this real quick.   And then that small part is easy enough to re- surface harden.
  
Back to top
 
IP Logged
 
kelleyrepair
Participating Member
*
Offline



Posts: 20
Location: Baja New York (FL)
Joined: Apr 28th, 2012
Re: Need Help - Problem with LW.
Reply #16 - Mar 18th, 2018 at 11:26am
Print Post  
But then on second thought, with so many functions being interconnected, so to speak, in the 1885, that process could create or increase firing pin tip drag in the fired primer??   So your mileage may vary from my experiences!
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0315 seconds.