ASSRA Forum › General › Gunsmithing Single Shot Rifles › Win Low wall 2 Part Extractor
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Win Low wall 2 Part Extractor (Read 1377 times)
Stractor
Junior Member
**
Offline



Posts: 94
Location: New Jersey
Joined: Jan 3rd, 2010
Win Low wall 2 Part Extractor
Aug 10th, 2015 at 11:28pm
Print Post  
Does any one have a picture/s of the DZ 2 part extractor in a rifle or a diagram showing the necessary modifications to a barrel to install one??? I have a picture of the extractor itself from the DZ website. I can't visualize how it is installed. I am doing a low wall in .17HMR and this seems like just the thing rather than the standard win .22 extractor.I read the posts on it but there is little visual info contained in them.
Thanks Bob
  
Back to top
 
IP Logged
 
SSShooter
Frequent Elocutionist
*****
Offline



Posts: 2923
Location: Southern NJ
Joined: Aug 1st, 2010
Re: Win Low wall 2 Part Extractor
Reply #1 - Aug 11th, 2015 at 9:52am
Print Post  
A slot is cut in the barrel to accommodate the small piece on the left in the picture, which is the extractor. The 'extractor lever', on the right, fits in just like the original extractor did, with the small rectangular 'tip' fitting into the matching 'notch' in the extractor. Suggest you send the barreled action to DanZ to do the installation. Works like a champ and you can't load a rim in front of it, which is the bane of the original extractor.
  
Glenn - 2x CPA 44 1/2 w/22LR (Shilen ratchet-rifled & Bartlein 5R rifled), 38-40RH & 38-55WCF (Bartlein 5R rifled) & 40-65WCF (GrnMtn 'X') barrels
Back to top
GTalk  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7242 seconds.