ASSRA Forum › General › Gunsmithing Single Shot Rifles › Ron Long Tang Sight
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Ron Long Tang Sight (Read 2381 times)
SSShooter
Frequent Elocutionist
*****
Offline



Posts: 2923
Location: Southern NJ
Joined: Aug 1st, 2010
Ron Long Tang Sight
Jun 9th, 2015 at 9:20am
Print Post  
Does anyone know what thread size Ron used for the eye-cup on his tang sight?
Thanks.
  
Glenn - 2x CPA 44 1/2 w/22LR (Shilen ratchet-rifled & Bartlein 5R rifled), 38-40RH & 38-55WCF (Bartlein 5R rifled) & 40-65WCF (GrnMtn 'X') barrels
Back to top
GTalk  
IP Logged
 
Chuckster
Frequent Elocutionist
*****
Offline



Posts: 2241
Location: Colorado
Joined: May 15th, 2008
Re: Ron Long Tang Sight
Reply #1 - Jun 10th, 2015 at 3:38pm
Print Post  
Buffalo Arms has a Hadley eyecup for Ron Long sights and say it is 1/4" x 40 TPI.
Chuck
  
Back to top
 
IP Logged
 
SSShooter
Frequent Elocutionist
*****
Offline



Posts: 2923
Location: Southern NJ
Joined: Aug 1st, 2010
Re: Ron Long Tang Sight
Reply #2 - Jun 11th, 2015 at 11:34am
Print Post  
Thank you.
  
Glenn - 2x CPA 44 1/2 w/22LR (Shilen ratchet-rifled & Bartlein 5R rifled), 38-40RH & 38-55WCF (Bartlein 5R rifled) & 40-65WCF (GrnMtn 'X') barrels
Back to top
GTalk  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7672 seconds.