ASSRA Forum › General › Gunsmithing Single Shot Rifles › New CPA rifle questions ??
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic New CPA rifle questions ?? (Read 2045 times)
Brudford01
Full Member
***
Offline



Posts: 196
Location: Beaver Falls PA
Joined: May 18th, 2008
New CPA rifle questions ??
Jun 6th, 2015 at 3:22pm
Print Post  
Just picked up my new CPA rifle today 6/6/15 in 32-40 . Several questions ? Having trouble removing the stock from the receiver, are there only the two wood screws holding it on ? Tight fit, do I need to take a rubber hammer to it ? Also some gun oil from the receiver has saturated the front of the stock, will laquer thinner remove the oil if I soak it for a couple of hours ? Thanks
  
Back to top
 
IP Logged
 
38-55
Full Member
***
Offline



Posts: 126
Location: central pa
Joined: Jul 18th, 2004
Re: New CPA rifle questions ??
Reply #1 - Jun 6th, 2015 at 3:55pm
Print Post  
congratulations on you 32-40.  You might need to tap the stock with a rubber mallet, make sure it does not have a thru bolt in the stock.  Have shot a 32-40 CPA for a number of yrs.  The accuracy is outstanding.  Breech seat a 200 gr, bullet over 14 grs. of 4227.  Enjoy.
  
Back to top
 
IP Logged
 
JLouis
Frequent Elocutionist
*****
Offline



Posts: 10625
Joined: Apr 8th, 2009
Re: New CPA rifle questions ??
Reply #2 - Jun 6th, 2015 at 7:22pm
Print Post  
Don't hit the top of the comb with a rubber hammer. Put the barrel in a padded vice and pull the butt stock straight back and off by hand it's suppossed to be tight! Don't worry about the oil just wipe any remaining off with a clean rag. Don't soak the pores of the end grain wood with any thing other than a good stock sealer.

JLouis


  
" It Is Better To Now Have Been A Has Been Than A Never Was Or A Wanna Be "
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.3482 seconds.