ASSRA Forum - Mounting an Unertl scope on a High Wall?

ASSRA Forum › General › Single Shot Rifles › Mounting an Unertl scope on a High Wall?

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

Mounting an Unertl scope on a High Wall? (Read 2427 times)

zeke Full Member Offline Posts: 142 Location: rural Joined: Mar 25^th, 2010	Mounting an Unertl scope on a High Wall? Oct 1^st, 2010 at 5:59pm	Print Post
	Hi again: I have a Unertl 15X UV that has been sitting in closet for many years and I am wondering if I drill and tap my "new" High Wall for scope blocks if this will detract from the resale value. I am at the age where iron sights are a problem. Any thoughts? T.I.A. Zeke


	IP Logged

westerner Frequent Elocutionist Offline deleted posts and threads record holder. Posts: 11331 Location: Why, out West of course Joined: May 29^th, 2006	Re: Mounting an Unertl scope on a High Wall? Reply #1 - Oct 2^nd, 2010 at 4:37pm	Print Post
	If it's a new rifle, scope blocks will increase the value. Joe.

	A blind squirrel runs into a tree every once in a while.
	IP Logged

azzhandler Junior Member Offline Posts: 65 Joined: Jul 14^th, 2007	Re: Mounting an Unertl scope on a High Wall? Reply #2 - Oct 2^nd, 2010 at 8:15pm	Print Post
	I had steve earl make me up a cantilever type mount for my browning 22-250 hi-wall,, it mounts in the factory holes on the receiver and extends out over the barrel, ive never had a problem with it yet, but alot of groundhogs have , give steve a call, he was cheaper then it would have cost to have the barrel drilled and tapped


	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 1.0630 seconds.