ASSRA Forum › General › Gunsmithing Single Shot Rifles › tang sight screws on a 44 1/2
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic tang sight screws on a 44 1/2 (Read 2155 times)
RJM
Full Member
***
Offline



Posts: 212
Location: State of Confusion
Joined: Oct 15th, 2006
tang sight screws on a 44 1/2
Sep 14th, 2010 at 9:32pm
Print Post  
What thread is on the tang sight screws on a Stevens 44 1/2 ? Looks like a #4 or #5 - pretty small.

I know I could look it up, but someone must know offhand. 

Thanks, 
Ron
  
Back to top
 
IP Logged
 
RJM
Full Member
***
Offline



Posts: 212
Location: State of Confusion
Joined: Oct 15th, 2006
Re: tang sight screws on a 44 1/2
Reply #1 - Sep 15th, 2010 at 8:11am
Print Post  
Thanks, Blindeye.

The screws that came with a repro pope sight are short, only have 2 threads engaging. I'll have to make a couple.

Regards,
Ron
  
Back to top
 
IP Logged
 
slumlord44
Frequent Elocutionist
*****
Offline



Posts: 2850
Location: Lebanon, Illinois 62254
Joined: Dec 21st, 2007
Re: tang sight screws on a 44 1/2
Reply #2 - Sep 15th, 2010 at 8:58pm
Print Post  
CPA has them.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7620 seconds.