ASSRA Forum › General › Gunsmithing Single Shot Rifles › #2 rolling block extractor
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic #2 rolling block extractor (Read 2334 times)
craig
Ex Member


#2 rolling block extractor
Jul 22nd, 2010 at 9:42pm
Print Post  
Does anyone have a picture or print of a sliding extractor and the cut in barrel shank?
  
Back to top
 
IP Logged
 
frnkeore
Frequent Elocutionist
*****
Offline



Posts: 7651
Location: Central Point, OR 97502
Joined: Jun 16th, 2010
Re: #2 rolling block extractor
Reply #1 - Jul 22nd, 2010 at 9:58pm
Print Post  
I have a 1897 #1 RB. They have sliding extractors. Mark DeHaas rebarreled mine more than 25 years ago. If you can contact him, he may be able to help you.

Frank
  
ASSRA Member #696, ISSA Member #339
Back to top
YIMAIM  
IP Logged
 
John Taylor
Frequent Elocutionist
*****
Offline



Posts: 1851
Location: Lewiston, ID
Joined: Oct 23rd, 2006
Re: #2 rolling block extractor
Reply #2 - Jul 23rd, 2010 at 9:58am
Print Post  
I could probably take a picture of the barrel threads with extractor groove but without having something to measure the angle it would be hard to reproduce without having the part in hand.  You can get a new extractor here (You need to Login or Register to view media files and links)
I have cut the groove in replacement barrels by marking where the retaining screw goes in and setting up the angle from that.
  
John Taylor   Machinist/gunsmith
Back to top
WWW  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.4161 seconds.