ASSRA Forum › General › Gunsmithing Single Shot Rifles › epoxy for glass bedding
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) epoxy for glass bedding (Read 11208 times)
Hammer47
Junior Member
**
Offline



Posts: 54
Joined: Jul 16th, 2008
Re: epoxy for glass bedding
Reply #15 - Jul 23rd, 2010 at 7:21pm
Print Post  
Marine Tex for the bedding and auto wax as a release agent.  I find that for small shop jobs such as this I weigh the 2 part Marine Tex to assure a correct mix.  I find that the mix BY WEIGHT is 7 to 1. IMHO it is too difficult to "eyeball" a 5/1 volumetric mix when weighing gets it "just right".....Regards...Gary
« Last Edit: Jul 24th, 2010 at 5:48pm by Hammer47 »  
Back to top
 
IP Logged
 
Stonewall
Ex Member


Re: epoxy for glass bedding
Reply #16 - Jul 25th, 2010 at 9:26pm
Print Post  
For release agent try Kiwi neutral shoe polish .
You can find it in Safeway etc in a small can.

Clean items then warm to touch with spotlight .
Apply with a cotton cloth under great light.
Wait ten minutes and buff with another cotton cloth .

I have used most release agents .
This is the best way so far.........

Glenn Grin
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.1352 seconds.