ASSRA Forum › General › Gunsmithing Single Shot Rifles › BSA International
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic BSA International (Read 2409 times)
Joe_S
Frequent Elocutionist
*****
Offline



Posts: 1107
Joined: Jun 29th, 2004
BSA International
Jul 11th, 2010 at 4:23pm
Print Post  
Does anybody know the Screw/thread size for the screw that holds the forend on the BSA International? I may need to make one and the original doesnt match up with anything I recognize. Thanks! Joe S
  
Back to top
 
IP Logged
 
Hammer47
Junior Member
**
Offline



Posts: 54
Joined: Jul 16th, 2008
Re: BSA International
Reply #1 - Jul 23rd, 2010 at 7:24pm
Print Post  
Just chase the threads with a 1/4X28 nf tap and then you can use the common SAE thread.
  
Back to top
 
IP Logged
 
Joe_S
Frequent Elocutionist
*****
Offline



Posts: 1107
Joined: Jun 29th, 2004
Re: BSA International
Reply #2 - Jul 23rd, 2010 at 8:12pm
Print Post  
Thanks Hammer, thats exactly what I did. Joe
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.4937 seconds.