ASSRA Forum › General › Gunsmithing Single Shot Rifles › Martini 12/15 receiver
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Martini 12/15 receiver (Read 2162 times)
jholp
Participating Member
*
Offline



Posts: 21
Location: Maryland
Joined: Oct 31st, 2008
Martini 12/15 receiver
Jan 24th, 2009 at 1:31pm
Print Post  
I have just acquired a stripped Martini 12/15 receiver.  It is nicely ground smooth on both sides, ready for bluing. 

I need to locate the entire inner parts for the receiver.  Cocking lever, trigger guard, trigger, bolt, firing pin, spring/s - the entire inner parts, even the main screw that holds the assembly in the action.

Any ideas on where to find all of these parts?

Thanks,

John



  
Back to top
 
IP Logged
 
MartiniBelgian
Frequent Elocutionist
*****
Offline



Posts: 1730
Location: Aarschot
Joined: Jun 7th, 2004
Re: Martini 12/15 receiver
Reply #1 - Jan 24th, 2009 at 2:33pm
Print Post  
Purchasing a complete action would probably be quite a bit cheaper than getting all parts to complete just a receiver...  And you'll be sure all parts match.
  
Back to top
WWW  
IP Logged
 
DoubleD
Oldtimer
*****
Offline



Posts: 766
Location: Edmond
Joined: Feb 14th, 2006
Re: Martini 12/15 receiver
Reply #2 - Jan 25th, 2009 at 1:05am
Print Post  
I might know where one is. PM me
  
Douglas, Ret.
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.1021 seconds.