ASSRA Forum - Stevens 44 1/2 Two screw Forend

ASSRA Forum › General › Gunsmithing Single Shot Rifles › Stevens 44 1/2 Two screw Forend

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

Stevens 44 1/2 Two screw Forend (Read 2269 times)

BP Frequent Elocutionist Offline Posts: 8039 Location: Westside Joined: Aug 27^th, 2006	Stevens 44 1/2 Two screw Forend Jan 10^th, 2009 at 1:48pm	Print Post
	Ended up with a 44 1/2 action the other day and am in the planning stage of designing a completed rifle. I'd like to go with a long two screw forearm, but don't have access to an original barrel to measure the proper locations for the forearm screw holes. Does anyone have measurements from an original? I know I can get fairly close by scaling from a picture, but I want to do justice to the old rifle and get it right. Thanks, BP

	There are three kinds of men: The ones that learn by reading, the few who learn by observation, and the rest who have to pee on the electric fence and find out for themselves. Proud Noodlehead
	IP Logged

Schuetzendave Frequent Elocutionist Offline Retired Ex-Shooter Posts: 4216 Location: St. Albert, Alberta Joined: Jan 28^th, 2005	Re: Stevens 44 1/2 Two screw Forend Reply #1 - Jan 10^th, 2009 at 3:03pm	Print Post
	From an original take down Stevens 28-30-120 44 1/2: Length of Forearm: 10 1/2 inches Distance Between Screw: 5 1/4 inches 1st Screw center from edge of receiver: 7/8 inches 2nd Screw center from edge of receiver: 6 1/8 inches Dave


	IP Logged

BP Frequent Elocutionist Offline Posts: 8039 Location: Westside Joined: Aug 27^th, 2006	Re: Stevens 44 1/2 Two screw Forend Reply #2 - Jan 10^th, 2009 at 9:03pm	Print Post
	Dave, Many thanks for the measurements and the rapid response! BP

	There are three kinds of men: The ones that learn by reading, the few who learn by observation, and the rest who have to pee on the electric fence and find out for themselves. Proud Noodlehead
	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 0.3555 seconds.