ASSRA Forum › General › Reloading the Single Shot Rifle › Loads for breach seated 32-40
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Loads for breach seated 32-40 (Read 2640 times)
mrballardman
Participating Member
*
Offline



Posts: 32
Location: California
Joined: May 4th, 2005
Loads for breach seated 32-40
May 4th, 2005 at 5:02pm
Print Post  
I have a Ballard and a hupburn that I shoot with breach seated bullets.  The bullets are about 219 gr and 1:20 (Ti/Lp).  I am experimenting with AA9.  Any suggestions as to amout of powder (gr) of AA9 to start with (and also a maximum).  Thanks in advance for the replies.
  
Ed
Back to top
 
IP Logged
 
PETE
Ex Member


Re: Loads for breach seated 32-40
Reply #1 - May 4th, 2005 at 8:14pm
Print Post  
mrballardman,

  Haven't tried for a maximum with AA#9 but if you'll try from about 13.0 to 13.5 grs. you should find something that'll work. My .32/40 High Wall likes 13.2 grs. with a 205 gr. bullet.

  I will say tho that all the .32/40's I have/had prefer 4227 better.

PETE
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0270 seconds.