Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Bullet alloy hardness (Read 174 times)
Oakdale
Full Member
***
Online



Posts: 137
Location: Maplewood, MN
Joined: Jun 7th, 2017
Bullet alloy hardness
Yesterday at 6:19pm
Print Post  
We often read here about the “optimum” alloy hardness for our Schuetzen bullets.

I’ve used alloys ranging from 16:1 to 30:1. It is difficult to discern an accuracy difference between the various hardness values. But might just be me.

My recollection is that 30:1 is often favored.

Has anyone conducted testing that would reveal a preferred hardness?

Thanks!

Tom
  
Back to top
 
IP Logged
 
Ranch13
Oldtimer
*****
Offline



Posts: 656
Location: East Central Wy.
Joined: Jan 20th, 2018
Re: Bullet alloy hardness
Reply #1 - Today at 10:41am
Print Post  
With target distance out to 5 maybe 600 yards alloy doesn't make a lot of difference, but beyond 600 it starts showing up in spades, due to nose slump etc.
For schützen and silhouette it's a matter of what you the rifle and target all agree works best.
  
Back to top
 
IP Logged
 
oneatatime
Frequent Elocutionist
*****
Offline



Posts: 4603
Location: Rocky Mountains
Joined: Oct 30th, 2011
Re: Bullet alloy hardness
Reply #2 - Today at 1:28pm
Print Post  
With BPCR I ran an extensive test with 30, 25, and 20 to 1. 25 was much better than 30 and 20 was better than 25. However, with one long nosed bullet had to go with 16 to 1 due to nose slump's effect at long distance.
  
Back to top
 
IP Logged
 
Joe_S
Frequent Elocutionist
*****
Offline



Posts: 1151
Joined: Jun 29th, 2004
Re: Bullet alloy hardness
Reply #3 - Today at 2:07pm
Print Post  
I have tried 16-1, 20-1,25-1, and 30-1 and settled on 30-1 because it breechseats a lot easier and shoots as well as anything else. With the velocities we shoot in Schuetzen I dont think it makes that much difference. However, for High power, such as .308, 30-06 and 8X57 I use wheelweights. 

I hope this helps. 
Joe S
  
Back to top
 
IP Logged
 
frnkeore
Frequent Elocutionist
*****
Offline



Posts: 7796
Location: Central Point, OR 97502
Joined: Jun 16th, 2010
Re: Bullet alloy hardness
Reply #4 - Today at 5:05pm
Print Post  
I shot both ~20/1 and 30/1 over the years. Never had the nerve to try 40/1, accept in 22rf.

In the '90's, I shot a couple of real good groups with 30/1 and started using it for a while but, I found that I would get more fliers with it. I have, rarely shot anything but, spitzers though so, that might be why.

I also tried 25/1 for a while but, settled on 22/1 and haven't changed since then.
  

ASSRA Member #696, ISSA Member #339
Back to top
YIMAIM  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint