ASSRA Forum › General › Gunsmithing Single Shot Rifles › welder recommendation
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic welder recommendation (Read 60 times)
cheatin_charlie
Senior Forum Member
****
Offline



Posts: 438
Location: ohio
Joined: Jan 10th, 2009
welder recommendation
Today at 11:25am
Print Post  
I have a friend that has a highly decorated European double rifle that has the tang broken 
behind the standing breach.  It is very thin and where one of the tang screws go through. I know somebody here has a recommendation and personnel experience with someone who could fix my friend up.  Please respond and I will pass the information to him.  Charlie
  
Back to top
 
IP Logged
 
bobw
Frequent Elocutionist
*****
Offline



Posts: 2240
Joined: Mar 19th, 2013
Re: welder recommendation
Reply #1 - Today at 11:53am
Print Post  
Have used both of these guys.

Peter Nagel
815-732-1249
Oregon, Il

Peter does work on antique firearms using tig welding.  I use him for, what I would call, a little courser work.  But, don’t take this wrong, he is very good and been doing this a long time.

Tony South
269-506-2760
Mattawan, MI

Tony does laser welding.  He may not be the right person for the job.  I have only used him for very fine welding of small parts.

I would talk to each of them and ask their advice.
Bob
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.5913 seconds.