ASSRA Forum › General › Reloading the Single Shot Rifle › Stuck sizing die in early Ideal bullet lubrisizer
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Stuck sizing die in early Ideal bullet lubrisizer (Read 41 times)
jimmy
Senior Forum Member
****
Offline


Now available in Oklahoma.

Posts: 489
Location: Skiatook
Joined: May 12th, 2009
Stuck sizing die in early Ideal bullet lubrisizer
Yesterday at 8:03pm
Print Post  
Used a heat gun to warm things up. Has a soft lube in the lubrisizer. It's early enough that the die is held in by a thumb wheel set screw. The die is not budging. Using a spacer to push it up with the handle. Anyone run into this. Lubrisizer has sat for a while. No rust apparent.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7725 seconds.