ASSRA Forum › General › Gunsmithing Single Shot Rifles › Fx for a slding extractor Swedish rolling block
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Fx for a slding extractor Swedish rolling block (Read 334 times)
BillOregon
Full Member
***
Offline



Posts: 197
Location: Hurley, New Mexico
Joined: Jul 28th, 2006
Fx for a slding extractor Swedish rolling block
Jul 11th, 2026 at 9:22pm
Print Post  
Fix for a sliding extractor 1873 Gustafs 12,7X44 R rolling block that doesn't always grab the case and lift it out. This has likely been covered oh, a hundred times before.
  
Back to top
 
IP Logged
 
marlinguy
Frequent Elocutionist
*****
Offline


Ballards may be weaker,
but they sure are neater!

Posts: 18134
Location: Oregon
Joined: Feb 2nd, 2009
Re: Fx for a slding extractor Swedish rolling block
Reply #1 - Jul 12th, 2026 at 10:28am
Print Post  
Only fix I know of Bill is to get another extractor, or take the one that doesn't quite work and have a good welder build up the end of the extractor to get a better grasp on the rim. Of course you'll need to shape the weld back down carefully until it fits and works properly. I prefer this method as another used extractor might not be any better.
Or for $20 you can buy a new casting from The Rifle Shoppe and fit it to your case rim.
(You need to Login or Register to view media files and links)
  
(You need to Login or Register to view media files and links)
Back to top
 
IP Logged
 
craigster
Oldtimer
*****
Offline



Posts: 829
Location: lost coast CA
Joined: Feb 20th, 2011
Re: Fx for a slding extractor Swedish rolling block
Reply #2 - Jul 15th, 2026 at 1:02pm
Print Post  
Give Ken a call.

(You need to Login or Register to view media files and links)
  
Back to top
 
IP Logged
 
John Taylor
Frequent Elocutionist
*****
Offline



Posts: 1868
Location: Lewiston, ID
Joined: Oct 23rd, 2006
Re: Fx for a slding extractor Swedish rolling block
Reply #3 - Jul 17th, 2026 at 8:11am
Print Post  
Most of the time i'm to impatient to wait on the mail to deliver one so I just make one from scratch. I have plenty of barrel scraps so having a piece of 4140 steel to make an extractor is no problem.
  
John Taylor   Machinist/gunsmith
Back to top
WWW  
IP Logged
 
BillOregon
Full Member
***
Offline



Posts: 197
Location: Hurley, New Mexico
Joined: Jul 28th, 2006
Re: Fx for a slding extractor Swedish rolling block
Reply #4 - Jul 22nd, 2026 at 5:24pm
Print Post  
Thank you for the replies, gentleman. Always nice to see a John Taylor post.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.9367 seconds.