ASSRA Forum - Who can do gunsmithing work on sights ?

ASSRA Forum › General › Gunsmithing Single Shot Rifles › Who can do gunsmithing work on sights ?

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

Who can do gunsmithing work on sights ? (Read 198 times)

Joe Do... Oldtimer ASSRA Board Member ASSRA Journal Editor Offline Posts: 663 Location: 'burbs of Chicago Joined: May 19^th, 2012	Who can do gunsmithing work on sights ? May 31^st, 2026 at 12:10pm	Print Post
	I have two rifles with sight issues. First, is a new-to-me Borchardt rifle. The sight staff and disk are Sharps, but the threaded screw may not be -and it is missing the little knurled knob for adjustment. The front sight is off my Farrow rifle. I have the adjustment knob and it looks like the threaded portion was turned down and pinned in place. How to remove the threaded portion and fit a new one is beyond me. If anyone has suggestions for a machinist that can do fine work, please share. Thank you, Joe D


	IP Logged

Dellet Frequent Elocutionist Offline Posts: 1298 Joined: May 19^th, 2017	Re: Who can do gunsmithing work on sights ? Reply #1 - May 31^st, 2026 at 1:57pm	Print Post
	Tony Maddox can probably help. Original Sight Company – The Original Sight Company (You need to *Login* or *Register* to view media files and links)


	IP Logged

jhm Frequent Elocutionist Offline Posts: 2030 Location: georgia Joined: Sep 4^th, 2011	Re: Who can do gunsmithing work on sights ? Reply #2 - May 31^st, 2026 at 7:23pm	Print Post
	I have tried to repair stuff like that and I found sights sometimes have some weird thread pitches so If you can't find taps and dies it becomes difficult. Single point threading small stock is difficult even on a good day. Not saying it can't be done it's just difficult. You need the right equipment. Yours can be repaired I am sure. If Tony can't help you I'll bet he can tell you who can... JMH


	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 0.6717 seconds.