ASSRA Forum › General › Reloading the Single Shot Rifle › I think I finally found THE load
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) I think I finally found THE load (Read 436 times)
bpjack
Frequent Elocutionist
*****
Offline



Posts: 3761
Location: East Olympia, WA
Joined: May 18th, 2008
Re: I think I finally found THE load
Reply #15 - Today at 8:27pm
Print Post  
Wes,

I looked at that mould and saw the large baseband. Should I reduce it?
  
Back to top
 
IP Logged
 
westerner
Frequent Elocutionist
*****
Offline


deleted posts and threads
record holder.

Posts: 12308
Location: Why, out West of course
Joined: May 29th, 2006
Re: I think I finally found THE load
Reply #16 - Today at 8:56pm
Print Post  
Yes. In the notes when ordering, tell them what dimensions you want.  I get best results with groove diameter bases so I ordered mine .326 My Remington barrel is .326. I don't remember the bore diameter.
  
A blind squirrel runs into a tree every once in a while.
Back to top
 
IP Logged
 
bpjack
Frequent Elocutionist
*****
Offline



Posts: 3761
Location: East Olympia, WA
Joined: May 18th, 2008
Re: I think I finally found THE load
Reply #17 - Today at 10:01pm
Print Post  
I have changed diameters a few times. I figured out that that 185P bullets we’re actually 30-1 so I am going to cast some with a couple of moulds in that weight range.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7087 seconds.