ASSRA Forum › General › Reloading the Single Shot Rifle › I hate casting
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 2 [3]  Send TopicPrint
Very Hot Topic (More than 25 Replies) I hate casting (Read 1484 times)
westerner
Frequent Elocutionist
*****
Online


deleted posts and threads
record holder.

Posts: 12398
Location: Why, out West of course
Joined: May 29th, 2006
Re: I hate casting
Reply #30 - Today at 8:19am
Print Post  
TomKlinger wrote Today at 7:39am:
After my many years in the Aerospace industry, I know there is No “repairing” flight hardware or electronics. My years in development and Quality Assurance. Forbids repair. Only replacement or at best “reworking” the defective part. Splices are a big no no unless approved by engineering after the rework has been process written and qualified….. a lengthy process…
Just saying,

PS I don’t mind casting…..

Tom Klinger

 





Same for me Tom. When a reject bullet pops out of a mold I never try to repair it. I just cast a new one. Aerospace industry and bullet casting, who woulda thunk they had anything in common.
  
A blind squirrel runs into a tree every once in a while.
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 2 [3] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.8015 seconds.