ASSRA Forum › General › Gunsmithing Single Shot Rifles › hornet reamer
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic hornet reamer (Read 163 times)
gwahir
Senior Forum Member
****
Offline


Ve gets too soon olt und
too late shmart.

Posts: 445
Location: montana
Joined: Dec 31st, 2005
hornet reamer
Mar 28th, 2026 at 12:03pm
Print Post  
I would like to get my old KHornet reamer reground to a regular  hornet. Who would do this?

  
Back to top
 
IP Logged
 
oneatatime
Frequent Elocutionist
*****
Offline



Posts: 4383
Location: Rocky Mountains
Joined: Oct 30th, 2011
Re: hornet reamer
Reply #1 - Mar 29th, 2026 at 12:53pm
Print Post  
OK. I'll voice the question a lot of folks may be thinking. Why?
  
Back to top
 
IP Logged
 
gwahir
Senior Forum Member
****
Offline


Ve gets too soon olt und
too late shmart.

Posts: 445
Location: montana
Joined: Dec 31st, 2005
Re: hornet reamer
Reply #2 - Mar 29th, 2026 at 1:08pm
Print Post  
My old KHornet reamer body has been touched up many times and is a bit under sized. There would be room to regrind the body it to a regular hornet.
  
Back to top
 
IP Logged
 
2152hq
Participating Member
*
Offline



Posts: 33
Joined: Oct 18th, 2024
Re: hornet reamer
Reply #3 - Mar 29th, 2026 at 4:55pm
Print Post  
Contact the orig mfg'r of that reamer.
They might do it. But will likely suggest just buy new one.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0437 seconds.