ASSRA Forum › General › Reloading the Single Shot Rifle › Belding Mull powder measure screw mystery.
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Belding Mull powder measure screw mystery. (Read 269 times)
jimmy
Senior Forum Member
****
Offline


Now available in Oklahoma.

Posts: 425
Location: Skiatook
Joined: May 12th, 2009
Belding Mull powder measure screw mystery.
Mar 9th, 2026 at 10:17pm
Print Post  
Cleaning up my Belding and Mull powder measure and there is a screw next to the handle pivot and I have no idea what it does. Any help? Its in the center of the picture. 

  
Back to top
 
IP Logged
 
25cal
Participating Member
*
Online



Posts: 49
Joined: Nov 27th, 2009
Re: Belding Mull powder measure screw mystery.
Reply #1 - Mar 10th, 2026 at 9:05pm
Print Post  
Haven't taken mine apart, but suspect it could be a retainer screw for the pin/screw that the link pivots on from under the moving block.
  
Back to top
 
IP Logged
 
jimmy
Senior Forum Member
****
Offline


Now available in Oklahoma.

Posts: 425
Location: Skiatook
Joined: May 12th, 2009
Re: Belding Mull powder measure screw mystery.
Reply #2 - Mar 10th, 2026 at 9:21pm
Print Post  
You are correct, it is a jam screw for the link screw under the sliding reservoir. Makes sense now. I'll take it back apart someday to confirm. 

Thanks 
  
Back to top
 
IP Logged
 
gnoahhh
Frequent Elocutionist
*****
Offline



Posts: 1034
Location: Gaithersburg, MD
Joined: Mar 31st, 2010
Re: Belding Mull powder measure screw mystery.
Reply #3 - Mar 11th, 2026 at 8:48am
Print Post  
Took the words out of my mouth!

Love the couple B&M's I have. 

Side note: gonna sell one or two but I need a drop tube for the one. Anybody have a spare?
  
Back to top
 
IP Logged
 
JHand
Full Member
***
Online



Posts: 218
Joined: Apr 15th, 2024
Re: Belding Mull powder measure screw mystery.
Reply #4 - Mar 11th, 2026 at 9:37am
Print Post  
gnoahhh wrote on Mar 11th, 2026 at 8:48am:
Took the words out of my mouth!

Love the couple B&M's I have. 

Side note: gonna sell one or two but I need a drop tube for the one. Anybody have a spare?


The MVA drop tube works great with the B&M with finer and more repeatable adjustments. Just in case you want to go that route...
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.9252 seconds.