ASSRA Forum › General › Gunsmithing Single Shot Rifles › extractor/ejector
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic extractor/ejector (Read 74 times)
gwahir
Senior Forum Member
****
Offline


Ve gets too soon olt und
too late shmart.

Posts: 429
Location: montana
Joined: Dec 31st, 2005
extractor/ejector
Today at 12:01pm
Print Post  
On a falling block, do you desire an ejector, or just a simple extractor?
  
Back to top
 
IP Logged
 
oneatatime
Frequent Elocutionist
*****
Offline



Posts: 4305
Location: Rocky Mountains
Joined: Oct 30th, 2011
Re: extractor/ejector
Reply #1 - Today at 1:10pm
Print Post  
If the Cape buffalo is coming for you an autoloader would be great. Some actions if opened smartly enough will turn the extractor into an ejector. But, for most of our purposes, an extractor is best so we don't have to go hunting the brass. Of course, if it is a 22, you may want the case to get well clear of the action when opening.
« Last Edit: Today at 1:23pm by oneatatime »  
Back to top
 
IP Logged
 
gwahir
Senior Forum Member
****
Offline


Ve gets too soon olt und
too late shmart.

Posts: 429
Location: montana
Joined: Dec 31st, 2005
Re: extractor/ejector
Reply #2 - Today at 2:25pm
Print Post  
oneatatime wrote Today at 1:10pm:
If the Cape buffalo is coming for you an autoloader would be great. Some actions if opened smartly enough will turn the extractor into an ejector. But, for most of our purposes, an extractor is best so we don't have to go hunting the brass. Of course, if it is a 22, you may want the case to get well clear of the action when opening.

Good points! From my perspective, an ejector system is a whole lot harder to design and build!
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.9657 seconds.