ASSRA Forum › General › General Discussion › Re: Trim some 405 brass
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Re: Trim some 405 brass (Read 154 times)
KFW
Oldtimer
*****
Offline



Posts: 621
Location: Wyoming
Joined: Dec 18th, 2016
Re: Trim some 405 brass
Jan 29th, 2026 at 11:44am
Print Post  
You need a Harbor Freight 2" chop saw. There are, or was 3d printed jigs for it on eBay. I have done 300 cases on mine.
  
Back to top
 
IP Logged
 
oneatatime
Frequent Elocutionist
*****
Offline



Posts: 4364
Location: Rocky Mountains
Joined: Oct 30th, 2011
Re: Trim some 405 brass
Reply #1 - Feb 9th, 2026 at 2:08pm
Print Post  
Those chop saws work great. I make small wooden chambers to slip the brass into which hold allow a quick cut  to very near the correct length and then trim to clean the cut.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.1565 seconds.