ASSRA Forum › General › Gunsmithing Single Shot Rifles › Highwall breechseater plans
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Highwall breechseater plans (Read 697 times)
RJ-35-40
Full Member
***
Offline



Posts: 190
Joined: Dec 7th, 2016
Re: Highwall breechseater plans
Reply #15 - Oct 23rd, 2025 at 2:48pm
Print Post  
Jack,

Thanks for your suggestion on the Modification.

As I have a number of Uberti's I am looking forward to getting it to work.

BTW, really like your craftsmanship.

THX

Bob
bpjack wrote on Oct 20th, 2025 at 3:44pm:
BPCRNUT,

Thanks for that information.  I have always said that my seaters are for original Winchesters, but one user got it to work in a Japanese version, but it needed some modification I believe.
Removing some metal from the nose end would probably get my design to work.  
The areas inside the red rectangles could be removed and it will still work.  Just a guess since I do not have an Uberti to test with. 

  
Back to top
 
IP Logged
 
bpjack
Frequent Elocutionist
*****
Offline



Posts: 3372
Location: East Olympia, WA
Joined: May 18th, 2008
Re: Highwall breechseater plans
Reply #16 - Oct 23rd, 2025 at 3:12pm
Print Post  
Thanks Bob.  It had taken a while to make the seater the way I wanted it to look.  I can't take credit for the design as it is a copy of one I bought off of eBay years ago.   

Jack
  
ASSRA # 11318
There are more hydrogen atoms in a single molecule of water than there are suns in the entire solar system.
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.2832 seconds.