ASSRA Forum › General › Gunsmithing Single Shot Rifles › Uberti High wall coil spring replacement
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Uberti High wall coil spring replacement (Read 249 times)
Joe_S
Frequent Elocutionist
*****
Online



Posts: 1036
Joined: Jun 29th, 2004
Uberti High wall coil spring replacement
May 24th, 2025 at 9:24pm
Print Post  
Hello everyone,
I had to replace the coil spring on my Uberti Low wall. Their coil spring does not have the ends of the spring pointing left and right but straight ahead. I got it installed, but the ends are sticking out. The ends are curved,( my guess is to aid in installation, but what do I know) and its the curved part that is sticking out. I think I have it installed correctly but since I have never done this before I am not 100% certain. Before I cut the ends of the spring off I want to make sure I am on the right track. If anyone can confirm, I would appreciate it. 
Thanks!
  
Back to top
 
IP Logged
 
Joe_S
Frequent Elocutionist
*****
Online



Posts: 1036
Joined: Jun 29th, 2004
Re: Uberti High wall coil spring replacement
Reply #1 - May 30th, 2025 at 8:26pm
Print Post  
From "
Blazing Saddles": "Wont somebody help that poor man?"

The fact that I have no  replies to this question might indicate that breaking the coil spring doesnt happen that often which is a good thing. I cut the ends of with a Dremel cut off wheel and de-burred the ends and it works fine, which was the obvious answer but just wanted to make sure I wasnt making a mistake. I have another problem with the half -cock notch listed separately, any help would be appreciated!
Thanks!
JOe
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0012 seconds.