ASSRA Forum › General › Gunsmithing Single Shot Rifles › seeking rocking horse dropping-Whitworth barrel
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) seeking rocking horse dropping-Whitworth barrel (Read 867 times)
Bnelson
Full Member
***
Offline



Posts: 174
Location: Lower Michigan
Joined: Jan 5th, 2009
Re: seeking rocking horse dropping-Whitworth barrel
Reply #15 - Jan 18th, 2025 at 8:41pm
Print Post  
Douglas, 
     I am interested in what you find out about the Whitworth rifling in a new barrel.  I have a Monkeytail that has Whitworth rifling but the barrel was cut off at about 15 inches.  Too bad because the original rifling is in great shape.  I’ve thought about getting a new Whitworth barrel and using it as a “Liner” onto the original barrel.   
Bruce
  
Back to top
 
IP Logged
 
DoubleD
Oldtimer
*****
Offline



Posts: 643
Location: Edmond
Joined: Feb 14th, 2006
Re: seeking rocking horse dropping-Whitworth barrel
Reply #16 - Jan 20th, 2025 at 9:19am
Print Post  
I haven't made any serious inquiries yet.   

I have to determine if what have, will shoot or not. It's to cold here in OK right now for this old guy to go to the range.

I did get my brass for this gun Buffalo Arms.

Given the nature of the responses, I have my doubts I will find a Whitworth rifle 8 groove .507 bbl..
  
Douglas, Ret.
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.4918 seconds.