ASSRA Forum › General › Gunsmithing Single Shot Rifles › Fitting a .22 LR Extractor in a .25 RF Stevens 44
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Fitting a .22 LR Extractor in a .25 RF Stevens 44 (Read 242 times)
rnnhntr
Participating Member
*
Offline



Posts: 31
Joined: May 18th, 2014
Fitting a .22 LR Extractor in a .25 RF Stevens 44
Dec 31st, 2024 at 4:41pm
Print Post  
Do you lengthen the firing pin relief groove below the rim cut in a .22 LR Extractor when fitting it in a .25 RF Stevens 44 action?
  
Back to top
 
IP Logged
 
bobw
Frequent Elocutionist
*****
Offline



Posts: 1597
Location: NW, Iowa
Joined: Mar 19th, 2013
Re: Fitting a .22 LR Extractor in a .25 RF Stevens 44
Reply #1 - Dec 31st, 2024 at 6:57pm
Print Post  
Probably will need to, so the firing pin can get to the shell rim.  As long as the pin clears your good.  Make the cut just wide enough for the pin, if you get carried away and get it to wide the pressure can pop the rims of the shell.
Bob
  
Robert Warren
Back to top
 
IP Logged
 
rnnhntr
Participating Member
*
Offline



Posts: 31
Joined: May 18th, 2014
Re: Fitting a .22 LR Extractor in a .25 RF Stevens 44
Reply #2 - Jan 4th, 2025 at 11:12pm
Print Post  
Kind of what I thought. Thank you for confirming.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.8019 seconds.