ASSRA Forum › General › General Discussion › Sketches?
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Sketches? (Read 290 times)
SchwarzStock
Frequent Elocutionist
*****
Offline



Posts: 1207
Location: SchwarzWald
Joined: Mar 23rd, 2010
Sketches?
Dec 16th, 2024 at 11:49am
Print Post  
Does anyone have sketches that illustrate the problems when a tang sight is mounted so it is can't to one side or the other?
  
If your rifle is not in 7.62 and you can't hit what you are aiming at with de-linked machinegun ammo you are a pretender.
Back to top
 
IP Logged
 
nuclearcricket
Oldtimer
*****
Offline



Posts: 759
Joined: Oct 15th, 2008
Re: Sketches?
Reply #1 - Dec 16th, 2024 at 12:35pm
Print Post  
I don't have a sketch but if your tang sight leans to one side or the other, as you increase elevation, your windage will also move. Picture the leaning tower of Pisa. If your looking at the lean, try drawing a straight line from the base up. As you go up, you have to go over to keep the line on the outside edge of the tower. 
Your rear sight will work the same way, just not as pronounced depending on the lean. 
Sam
  
Back to top
 
IP Logged
 
SchwarzStock
Frequent Elocutionist
*****
Offline



Posts: 1207
Location: SchwarzWald
Joined: Mar 23rd, 2010
Re: Sketches?
Reply #2 - Dec 16th, 2024 at 12:52pm
Print Post  
Right, I know that. I am looking for some sketches so I don't have to create them.
  
If your rifle is not in 7.62 and you can't hit what you are aiming at with de-linked machinegun ammo you are a pretender.
Back to top
 
IP Logged
 
rgchristensen
Frequent Elocutionist
*****
Offline



Posts: 1105
Joined: Jan 2nd, 2014
Re: Sketches?
Reply #3 - Dec 16th, 2024 at 1:51pm
Print Post  
SchwarzStock wrote on Dec 16th, 2024 at 11:49am:
Does anyone have sketches that illustrate the problems when a tang sight is mounted so it is can't to one side or the other?


The way I fix this is to put the rifle in a vise with the bubble in the front sight “in the middle”.   Then shim the rear sight so that it is vertical, using a bubble level.  Piece of cake....

CHRIS
  
Back to top
 
IP Logged
 
SchwarzStock
Frequent Elocutionist
*****
Offline



Posts: 1207
Location: SchwarzWald
Joined: Mar 23rd, 2010
Re: Sketches?
Reply #4 - Dec 20th, 2024 at 9:43am
Print Post  
Thanks guys but I am looking for some sketches to make a point with someone.
  
If your rifle is not in 7.62 and you can't hit what you are aiming at with de-linked machinegun ammo you are a pretender.
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.6227 seconds.