ASSRA Forum › General › General Discussion › Case sizing problems
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Case sizing problems (Read 996 times)
plumloco
Full Member
***
Offline



Posts: 139
Location: Manassas ,VA
Joined: May 20th, 2004
Re: Case sizing problems
Reply #15 - Dec 6th, 2024 at 8:14am
Print Post  
Hello, I use STP oil treatment. I've had the same bottle over 20 years. Use VERY lite coats. I have a rag in a plastic jar top. About 5 " round. One pass and for the second pass use what is on your fingers. I then clean with corn cob. Plumloco
  
Back to top
 
IP Logged
 
condorsc
Full Member
***
Offline


NRA Life/Benefactor, ASSRA,
SCV Life

Posts: 157
Location: Beaufort, S.C.
Joined: Nov 13th, 2021
Re: Case sizing problems
Reply #16 - Dec 19th, 2024 at 11:57am
Print Post  
Spud wrote on Dec 5th, 2024 at 11:13pm:
Mike, if you can't find Imperial wax I find that lanolin grease works just as well. I've used this to form .33 WCF & .38/56 WCF from .45/70 brass.
Pete S (Spud)

 
If your wife/partner uses AQUAPHOR, try it on sizing. Works just like Imperial, does a great job. And it's free.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.2303 seconds.