Page Index Toggle Pages: 1 2 3 [4]  Send TopicPrint
Very Hot Topic (More than 25 Replies) Some Stuff About Ballard Seaters (Read 2685 times)
Skalkaho
Oldtimer
*****
Offline



Posts: 785
Location: Montana
Joined: Sep 29th, 2006
Re: Some Stuff About Ballard Seaters
Reply #45 - Oct 1st, 2024 at 1:02pm
Print Post  
Sweet GT. If I can help you in any way drop a note...Pete
  

May the Bullet Gods be with you.......
Back to top
 
IP Logged
 
GT
Frequent Elocutionist
*****
Offline



Posts: 2041
Location: Northeast Wyoming
Joined: Jun 28th, 2015
Re: Some Stuff About Ballard Seaters
Reply #46 - Oct 1st, 2024 at 1:26pm
Print Post  
Wes,
That is a concern of mine with this design and I'll definitely bear this in mind using it...
Pete, 
I started this leaving considerable material on it, your picture of the seater in the action gave me proportions to work off of.  If there is any way you could lay a small scale next to it and snap a picture I'd appreciate it.  The internals are fairly simple but seeing them and the way they mount the case to the seater would be helpful.  Email on the way.
Bob, 
I have a sketch, working through it and I'll share it later.
Started the lever this a.m.
  

"To invent, you need a good imagination and a pile of junk"  T. A. Edison
"The trouble ain't that there is too many fools, but that the lightning ain't distributed right" M.T.
Back to top
 
IP Logged
 
Skalkaho
Oldtimer
*****
Offline



Posts: 785
Location: Montana
Joined: Sep 29th, 2006
Re: Some Stuff About Ballard Seaters
Reply #47 - Oct 2nd, 2024 at 5:14pm
Print Post  
Heres the 25-20 Ballard that goes with the breech seater !
BS taken apart.....Doing good Greg  !!
« Last Edit: Oct 3rd, 2024 at 8:53am by Skalkaho »  

May the Bullet Gods be with you.......
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 2 3 [4] 
Send TopicPrint