Page Index Toggle Pages: 1 [2] 3  Send TopicPrint
Very Hot Topic (More than 25 Replies) Reloading handbook (Read 2116 times)
burntwater
Senior Forum Member
****
Offline



Posts: 402
Location: Michigan
Joined: Feb 5th, 2018
Re: Reloading handbook
Reply #15 - Sep 20th, 2024 at 3:10pm
Print Post  
If you’re a woodworker you can’t have too many clamps and reloaders can’t have too many reloading reference books. But every library should have Sharpe’s compendium regardless of dated propellant info. The bullet manufacturer manuals are fine but frankly it’s take three or four releases to get enough fresh info to justify the cost. Otherwise they more or less rehash much of the same data and always with a preference for their product but generally with a few new powders or wildcats. Lyman has always been a cut above most of these but still a lot of redundant information. 

A real jewell are the two ‘ Pet Loads ‘ volumes by Ken Waters. Though again some of the powder specs are dated he supplies enough insight and testing for a serious reloaders to cross reference and find the answer. But all of his ‘Pet Loads’ provide great info on different gun characteristics and how to tailor loads for them. Great info on monitoring pressure signs and how to creep up without getting into trouble. Lots of info on bullet designs both cast and jacketed,  seating depth and case prep. Just lots of information the other manuals don’t offer. Waters was a life long experimenter and loved his big collection of single shots so he deals with them a lot.

Another very handy source is ‘ Propellant Profiles ‘ the only source I know of that addresses almost every powder out there with enough load data to give a reloader information on where different powders fit. Each powder is given some brief history, its chemical make up, relative burn rate, density etc. 

Ackley’s books push the pressure boundaries so need some discretion but he explains in depth case design, the question of overbored cartridges from a barrel makers view but remember it’s old powder data so he would, if still alive, have many different conclusions today.  He was alway fixated on cartridges that gave optimal performance per bore size or ballistic efficiency. Still to this day an ongoing debate. 

Rick
  
Back to top
 
IP Logged
 
CharleHunter
Senior Forum Member
****
Offline



Posts: 363
Joined: Feb 8th, 2019
Re: Reloading handbook
Reply #16 - Sep 21st, 2024 at 6:38am
Print Post  
Just did a quick count and have around 30 reloading manuals including Sharpe's book. All have something worth while to contribute. As an example, an older Hornady edition provide information on the 6.5x57 Mauser for my model 21 BRNO bolt gun. 

I also subscribe to Load data as it has a great deal of useful load information on odd calibres.

Steve in Aus.
  
Back to top
 
IP Logged
 
yamoon
Oldtimer
*****
Offline


NRA Life, ASSRA , GGCA,
MCA

Posts: 880
Location: Junction City Kansas
Joined: Feb 11th, 2012
Re: Reloading handbook
Reply #17 - Sep 21st, 2024 at 10:25am
Print Post  
I’ve been reloading for close to 60 years, if only the internet and the AASRA forum had been available then. It is easy to forget the mistakes I made in the early days. I have Sharpe’s book, Nonte’s guide to cartridge conversion, and several reloading manuals.
Mike
  
Back to top
 
IP Logged
 
craigster
Oldtimer
*****
Offline



Posts: 684
Location: lost coast CA
Joined: Feb 20th, 2011
Re: Reloading handbook
Reply #18 - Sep 21st, 2024 at 1:26pm
Print Post  
Judge 1879 wrote on Sep 20th, 2024 at 7:57am:
sounds like I need to clear a bookshelf in the shop. ok starting with the 49th issue of lyman and then down the rabbit hold I go. thanks guys!


I have Sharpe's book if you looking for one to buy. Excellent condition. $50 to your door.
  
Back to top
 
IP Logged
 
burntwater
Senior Forum Member
****
Offline



Posts: 402
Location: Michigan
Joined: Feb 5th, 2018
Re: Reloading handbook
Reply #19 - Sep 21st, 2024 at 1:42pm
Print Post  
One last comment ( maybe ) I have to say growing up in SoCal amongst a large firearms and drag racing community including my next door neighbor Frank Snow who built an obscure bullet making company called Sierra in two Quonset huts and many others who showed me more than a kid like me was was entitled too I’d have been stuck shooting mostly 22’s due to cost of boxed ammo. If it wasn’t for those WW II and Korean vets being so generous I doubt I could have been able to even imagine jumping into the world of reloading. 

Books are great, they don’t die or move,  but to me my old mentors were the true source of knowledge. Just going to a match and watching the wise is worth a shelf of books. I mean why do you think this forum is so valuable ?

Rick talk too much 
Rick
  
Back to top
 
IP Logged
 
craigster
Oldtimer
*****
Offline



Posts: 684
Location: lost coast CA
Joined: Feb 20th, 2011
Re: Reloading handbook
Reply #20 - Sep 21st, 2024 at 2:06pm
Print Post  
The Handbook of Cartridge Conversions,  J.P. Donnelly.
  
Back to top
 
IP Logged
 
rkba2nd
Frequent Elocutionist
*****
Online



Posts: 1931
Location: earth
Joined: Feb 16th, 2009
Re: Reloading handbook
Reply #21 - Sep 21st, 2024 at 2:34pm
Print Post  
There is a newer book out by Fred Zeglin, Wildcat Cartridge Design. New to me, so have not read this one yet, but have read the earlier, and well worth the time.
  

rkba2nd
Back to top
 
IP Logged
 
boats
Frequent Elocutionist
*****
Offline



Posts: 7545
Location: Virginia
Joined: Apr 23rd, 2004
Re: Reloading handbook
Reply #22 - Sep 21st, 2024 at 4:33pm
Print Post  
50 for Sharpe’s is a bargain I paid that years ago and had to re-bind on top of it.  It is autographed and bought it at the Baltimore gun show, no bargains there 

Boats
  
Back to top
 
IP Logged
 
yamoon
Oldtimer
*****
Offline


NRA Life, ASSRA , GGCA,
MCA

Posts: 880
Location: Junction City Kansas
Joined: Feb 11th, 2012
Re: Reloading handbook
Reply #23 - Sep 21st, 2024 at 5:16pm
Print Post  
craigster wrote on Sep 21st, 2024 at 2:06pm:
The Handbook of Cartridge Conversions,  J.P. Donnelly.

Available to read free on Internet Archive 
Mike

  
Back to top
 
IP Logged
 
yamoon
Oldtimer
*****
Offline


NRA Life, ASSRA , GGCA,
MCA

Posts: 880
Location: Junction City Kansas
Joined: Feb 11th, 2012
Re: Reloading handbook
Reply #24 - Sep 21st, 2024 at 5:21pm
Print Post  
Link (You need to Login or Register to view media files and links)
Mike
  
Back to top
 
IP Logged
 
boats
Frequent Elocutionist
*****
Offline



Posts: 7545
Location: Virginia
Joined: Apr 23rd, 2004
Re: Reloading handbook
Reply #25 - Sep 21st, 2024 at 5:38pm
Print Post  
Agree with Burntwater on the Wolfe Publishing books. The two Pet Loads books are gems. Propellant Profiles essential to understanding the differences In Powders and how they perform. 

Also agree about Ackleys books. Interesting reading and you will learn a lot. Just be aware Ackley was a hot rodder and pushed the envelope. 

Best gun and shooting library I know of belongs to one of our members. Won’t name him, don’t want to draw a crowd to his font door.

Boats
  
Back to top
 
IP Logged
 
craigster
Oldtimer
*****
Offline



Posts: 684
Location: lost coast CA
Joined: Feb 20th, 2011
Re: Reloading handbook
Reply #26 - Sep 21st, 2024 at 5:42pm
Print Post  
Cast Bullets, E.H. Harrison.
 
I also have a copy for sale. $50 TYD.
« Last Edit: Sep 21st, 2024 at 6:10pm by craigster »  
Back to top
 
IP Logged
 
marlinguy
Frequent Elocutionist
*****
Offline


Ballards may be weaker,
but they sure are neater!

Posts: 16091
Location: Oregon
Joined: Feb 2nd, 2009
Re: Reloading handbook
Reply #27 - Sep 21st, 2024 at 7:30pm
Print Post  
I have found that there's very little in the way of modern loading manuals that cover the vast majority of old single shots I shoot. Most don't even mention the cartridges I load for. 
Some of the newer cast bullet manuals have loads for .45-70 or .38-55, but even common cartridges like .40-65 or .32-40 aren't covered. 
I rely on old Ideal loading manuals from the pre WWII era, and a ballistic program I use. I sometimes find data for similar volume cartridges, and begin working up my loads using minimum data for those until I get a load that's accurate.
  

(You need to Login or Register to view media files and links)
Back to top
 
IP Logged
 
sharps4590
Junior Member
**
Offline



Posts: 88
Joined: Mar 24th, 2016
Re: Reloading handbook
Reply #28 - Sep 21st, 2024 at 9:56pm
Print Post  
boats wrote on Sep 20th, 2024 at 9:40am:
No telling how many I have but think Sharpe’s compete guide is the best. Long out of print can be hard to find. My copy had binding problems, had it re-bound.  Lyman’s one of the best and easiest to buy. Older editions often as good as the new ones for older cartridges. NRA books very good too, if they are still in print. Try ASSRA’s books for sale section back of the journal. Some real bargains there. 
Boats


Sharpes book is readily available as a reprint.....and as soon as I can remember who reprints them, for a reasonable price I might add, I'll post it.   

HA!!!!  I found it on line!!!

(You need to Login or Register to view media files and links)

Speaking of "on line data", it's ok but, books are better and once you have them they aren't subject to change or deletion.
  
Back to top
 
IP Logged
 
boats
Frequent Elocutionist
*****
Offline



Posts: 7545
Location: Virginia
Joined: Apr 23rd, 2004
Re: Reloading handbook
Reply #29 - Sep 22nd, 2024 at 6:28am
Print Post  
Glad to hear Cornell reprinted Sharpe’s Complete Guide. Will pass the info along our club

Boats 

  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 3 
Send TopicPrint