ASSRA Forum - Wanting to Restore a Lyman Scope

ASSRA Forum › General › Gunsmithing Single Shot Rifles › Wanting to Restore a Lyman Scope

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1 2 3 [4]

Wanting to Restore a Lyman Scope (Read 3969 times)

rkba2nd Frequent Elocutionist Offline Posts: 1944 Location: earth Joined: Feb 16^th, 2009	Re: Wanting to Restore a Lyman Scope Reply #45 - Sep 24^th, 2024 at 1:31pm	Print Post
	ONE COULD ORDER A 438 SCOPE WITH THE STANDARD MOUNTS(CHEAP), OR THE BETTER(STEEL), AT EXTRA COST. I HAVE HAD QUITE A NUMBER WITH EITHER.

	rkba2nd
	IP Logged

rkba2nd Frequent Elocutionist Offline Posts: 1944 Location: earth Joined: Feb 16^th, 2009	Re: Wanting to Restore a Lyman Scope Reply #46 - Sep 24^th, 2024 at 1:38pm	Print Post
	You certainly shamed Lyman on you saving this scope, well done!

	rkba2nd
	IP Logged

bobw Frequent Elocutionist Offline Posts: 1531 Location: NW, Iowa Joined: Mar 19^th, 2013	Re: Wanting to Restore a Lyman Scope Reply #47 - Sep 26^th, 2024 at 6:46pm	Print Post
	New home for this scope. Sets a bit higher than I like but it's workable. Made the rear block so I could use existing hole in the barrel. This little Steven's Marksman had many issues when I got it. It ended up with a liner to correct a chamber someone messed up and had what looked like a nail for a firing pin. For a boys rifle is shooting pretty darn good. Fun gun. This is one that will end up with the grandson.....or granddaughter. Bob
	« Last Edit: Sep 26^th, 2024 at 6:51pm by bobw »
	Robert Warren
	IP Logged

TDW Full Member Offline Posts: 118 Location: Montana and Missouri Joined: Mar 21^st, 2010	Re: Wanting to Restore a Lyman Scope Reply #48 - Sep 27^th, 2024 at 10:29am	Print Post
	That’s a neat package! Nice job of salvaging, Bob!👍 Tom W.

	"The farther North you go, the more things you will run into that will eat your horse." S.P. Garbe, Absaroka-Beartooth Wilderness, 1980
	IP Logged

Pages: 1 2 3 [4]

‹ Previous Topic | Next Topic ›

Page completed in 0.6678 seconds.