Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic bsa mk2 international malfunction (Read 381 times)
rap2233
Participating Member
*
Offline



Posts: 13
Location: Ma.
Joined: May 11th, 2020
bsa mk2 international malfunction
Aug 12th, 2024 at 10:10pm
Print Post  
Hello I was shooting Sat. morning ,had a malfunction, I pulled the action and it seemed like the firing pin failed to retract, not thinking I put it back together and of coarse it will not open.
I am a little frustrated as this is one of my favorite rifles for club matches.
  
Back to top
 
IP Logged
 
oneatatime
Frequent Elocutionist
*****
Offline



Posts: 3871
Location: Rocky Mountains
Joined: Oct 30th, 2011
Re: bsa mk2 international malfunction
Reply #1 - Aug 13th, 2024 at 12:59am
Print Post  
Did you try pushing the firing pin back into the block with a cleaning rod?
  
Back to top
 
IP Logged
 
Schuetzendave
Frequent Elocutionist
*****
Offline


Retired Ex-Shooter

Posts: 4044
Location: St. Albert, Alberta
Joined: Jan 28th, 2005
Re: bsa mk2 international malfunction
Reply #2 - Aug 13th, 2024 at 2:04pm
Print Post  
Firing pin is retracted out after pulling the trigger.

If you cock the action by opening the lever is the firing pin still retracted out?

Try cocking the rifle and then taking the action out.
  
Back to top
 
IP Logged
 
bnice
Frequent Elocutionist
*****
Offline



Posts: 1851
Location: Iowa
Joined: Nov 30th, 2006
Re: bsa mk2 international malfunction
Reply #3 - Aug 13th, 2024 at 3:29pm
Print Post  
if the lever wont cock, try flipping it upside down and shaking lever. I know sounds weird but I had an extractor break out on one side of the retaing pin. The piece jamed everything up. Probably not your issue but worth a try. good luck
  
Back to top
 
IP Logged
 
rap2233
Participating Member
*
Offline



Posts: 13
Location: Ma.
Joined: May 11th, 2020
Re: bsa mk2 international malfunction
Reply #4 - Aug 18th, 2024 at 9:46pm
Print Post  
Well to-nite I'd give another try ,to get it apart. the cleaning rod didn't do anything, so I started taping and rotating the action. 
after awhile the action dropped some and I started driving out the pins that were exposed, and the action dropped out.
I don't know the proper name of the part, but it's a cam with a paw on it that's broken off. Next I will need to one or have one made.    *  Fond a cross section of the rifle, the part is called a (tumbler).
« Last Edit: Aug 18th, 2024 at 10:14pm by rap2233 »  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint