ASSRA Forum › General › Reloading the Single Shot Rifle › Accurate mold website
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Accurate mold website (Read 717 times)
wcf3840
Senior Forum Member
****
Offline


ASSRA Life #299

Posts: 347
Location: Palatine
Joined: May 28th, 2007
Re: Accurate mold website
Reply #15 - Jun 19th, 2024 at 7:06pm
Print Post  
I just got an email from Tom regarding an order. Everything sounded fine. It did take him a while to respond, but respond he did.
  
Back to top
GTalk  
IP Logged
 
KFW
Oldtimer
*****
Offline



Posts: 541
Location: Powell Wy.
Joined: Dec 18th, 2016
Re: Accurate mold website
Reply #16 - Jun 20th, 2024 at 7:18am
Print Post  
KFW wrote on Jun 19th, 2024 at 10:45am:
gnoahhh wrote on Jun 19th, 2024 at 7:26am:
I heard through the grapevine that Tom has "officially" retired, and that he had recently sold the company and had been staying on as an advisor while the newbies get acclimated. Not from the horse's mouth, so to speak. Perhaps if that were the case there's changes being orchestrated with the website?

I hope the doors are open, My mold that just arrived is bored undersized, so either wrong  or "they" sent the wrong one. I hate it when there is no correspondence available to resolve a issue. That said it is a fine looking iron mold, just wrong.

Received a email last evening from Tom about resolving the mold issue. So all will be well, I see the web site is back up also.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.1590 seconds.