ASSRA Forum › General › Reloading the Single Shot Rifle › IMR 4064 Loads
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic IMR 4064 Loads (Read 249 times)
4570mike
Senior Forum Member
****
Offline



Posts: 356
Location: On the Peninsula
Joined: Apr 11th, 2013
IMR 4064 Loads
Mar 21st, 2024 at 1:34pm
Print Post  
Anyone use IMR 4064 in the common BPCR straight wall cases? (45-70, 40-65, 38-55)

I used this for a long time in 30-06 and have some sitting around.  With the high prices and difficulty finding powder, it would be good to put it to use.

Mike.



  
Back to top
 
IP Logged
 
Bulseyetom
Oldtimer
*****
Offline



Posts: 946
Location: Santa Maria, Ca
Joined: Oct 31st, 2010
Re: IMR 4064 Loads
Reply #1 - Mar 21st, 2024 at 3:07pm
Print Post  
I am using it in my 40-70 SS with paper patched bullets as the case is almost full so with a few poly wads the bullet seating depth is fixed so the bullet can't slide into the case.  This is a full power load in a modern Sharps and will let you know you pulled the trigger!  Tom
  
Back to top
Twitter  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0619 seconds.